Tips for Product Use

1. Position vehicle on trailer.  Move vehicle as necessary to balance trailer for Tongue Weight Distribution.
2. Attach one (1) pair of Tie-Downs to front end of vehicle at a point below suspension system and in a manner preventing strap movement.    
   (a) Attach Ratchet end of Tie-Downs to trailer bed attachment hardware.  
   (b) Activate ratchet and apply equal tension to each Tie-Down strap.
3. Attach one (1) pair of Tie-Downs to rear end of vehicle at a point below suspension system and in a manner similar to that described above for the front end of the vehicle.

NOTES:

Webbing should be protected against contact with sharp edged parts, hot surfaces and acids.  Do Not Use Tie-Down if webbing is cut, frayed or damaged.

To achieve tie-down load rating, all strap components must be in straight line with the direction of pull.

Hardware should have load rating equal to or greater than the rating of the Tie-Downs.

Criss-Crossing of the Tie-Downs should be used only when both ends of Tie-Down strap are securely locked in a fixed position to vehicle component and to trailer attachment point prohibiting Tie-Down movement.

VINYL "S" HOOKS are applied to both ends of all M&R Motorcycle/ATV Tie-Downs, to protect your cycle's paint and chrome parts and your truck or trailer.MINIMUM BREAK RATING (MBR) is the minimum tension load an assembly will restraint without failure, when in new-unused condition.

OVERALL LENGTH is the unit operating length when measured hook end to hook end.

M&R TIE-DOWN RATINGS are based on the rating of the weakest component. Higher webbing and sewing patters are provided for added abuse and abrasion resistant characteristics. Care should be taken to ensure that the appropriate rated assembly(s) is used for each load.